Hello,

I’m creating a BoM for a youth group project. We’re planning on building the Electromagnetic Ring Accelerator from Hyperspace Pirate. He’s provided the 3d print files, but not the finer details on wire gauge, enamel wire gauge and ball size. I also want to confirm the photoresistor. Are there different photoresistors with with different sensitivities or ranges?

I’ve included the wip of the BoM.

  • isolatedscotch@discuss.tchncs.de
    link
    fedilink
    English
    arrow-up
    3
    ·
    edit-2
    8 months ago

    I’m guessing you watched the first video, the one with a single coil, which, as you said, doesn’t specify those details. However, on a later video ( https://www.youtube.com/watch?v=uNbL3tRZeMQ ), where he makes some improvements to the whole circuit, there are some details mentioned in the description, such as

    Input voltage: 24V

    Number of coils: 4

    Wire Gauge: 24AWG

    Coil Current: 13A

    Coil ID: 1.1"

    Coil OD: 1.4"

    Coil Length: 0.5"

    Coil turns: 200

    The final outer diameter is ~2" due to the addition of steel wire to create a magnetic flux guide or “shell”.

    FET Type: IRLZ44N

    On time: ~8 ms at max. speed

    Energy input per pulse: 2.6J

    Ball mass: 65 grams

    Ball kinetic energy: ~0.52J

  • renormalizer@feddit.de
    link
    fedilink
    English
    arrow-up
    1
    ·
    edit-2
    8 months ago

    IIRC, the first model ate mosfets for breakfast because the photo resistor is way too slow going from illuminated to dark. That leaves the mosfet in a fairly high resistance state for an extended amount of time during which it dissipates a lot of power. You should add some kind of Schmitt trigger inverter that buffers the resistive divider and gives you a clean narrow edge to drive the mosfet gate. A 74HC14 together with a 7805 voltage regulator should give you enough output voltage to drive the mosfet. These chips cost less than a single replacement mosfet and you can drive 6 coils with them.