Its a slight tweak of the profile I use with other sunlu pla filament.

I’ve tried to top layer setting tweaking bit not luck so far

Thanks for the tip

Might have to save this as a last resort 😅

Sorry?

Thinks for the tips

There’s a massive blob stuck round the thermistor wires that is detached from the hot end. Tried to melt the blob but cant get the middle to heat up.

If the wires do get broken are they easy to replace ?

Made a lot of progress but it is in the screwheads the attach the hot end. Ridiculous

Looks to be about £30 I think. Although looking at the service video I can’t actually get to the screws to remove the hot end because they are covered in pla

Thank you for linking. I have no idea how I didn’t find it in my searches round printables!

Appreciate the help

Ah ok. It can’t do what I’m after then. I use Nova do that tap signal opens a specific contact chat and swiping opens it normally.

Can’t find another laincher that can do that

Just downloaded Hyperion and trying to add gestures to apps but cannot see where.

Am I missing something obvious?

Red Dwarf.

Watched The Fugitive last night. First time seeing it and though it was great. Some of the special effects aged well, some… Did not.

Completely agree about season two. It’s been a bit of disappointment so far

What is an example of a private town in the UK?

Adam and the metal hawks do a few fun songs. Some covers and some original. “Love is on my wishlist” is good