Same. And the coffee is really really good

1. It helps ensure that levels between 2.5v and 5.5v can be fed to the controller without breaking anything. For some cheaper power supplies you might get a voltage drop when starting to pull load, this will clean that up and prevent the voltage from dropping too low for the microcontroller.

2. If I’m reading the correct datasheet I can see it is current limiting so it should shutdown when overdrawn.

If I’m reading the part number right that regulator is rated for a current limit of 400mA At 5v that’s 2 watts.

U

Wtf is this article?

I feel positive today

It’s real embarrassing to post a comment with your porn alt

Same. I tend to block all the local communities. Like tbh I don’t really care what’s happening in like Boston